Book a call
Train · CandCNC

Make your CandCNC plasma table cut clean

For DIY builders, makers, and pro shops running CandCNC. Setup, wiring, THC tuning, software, and troubleshooting — taught by someone who's run the equipment, not read the manual.

Book a training session

What you'll learn

From confused to confident on your CandCNC system — and a table that cuts clean and consistent.

Controller & electronics setup — wiring, grounding, and clean signal
THC (torch height control) tuning for consistent cut quality
Motion, homing, and post-processor configuration
Cut charts, consumables, and dialing in by material
Nesting and CAM workflow, start to finish
Troubleshooting and a maintenance playbook for your table

Session options

Start here

Rescue Session

Your CandCNC table won't cut right and you need a fast, specific fix.

$150 – $250/hr

Remote · 2-hr block $275–$450

  • Live screen-share troubleshooting
  • Fix config, THC, motion, or post issues
  • Tuned settings + written cheat-sheet
  • Session recording for reference

Plasma Mastery Intensive

An owner or crew that wants to go from confused to confident, end to end.

$750 – $3,500

Half/full day · remote or onsite + travel

  • Structured half or full day
  • Setup, THC, cut charts, CAM workflow
  • Maintenance + troubleshooting playbook
  • Quick-reference guide + 2 weeks follow-up
  • Add seats for the whole crew
Safety first: hands-on plasma training is done on your machine at your shop, with a signed safety briefing and required PPE. It keeps everyone covered and lets us focus on real cuts.

Common questions

Is this just for CandCNC tables?

That's my specialty — CandCNC controllers and electronics are what I know cold. If you're on a CandCNC system and it won't cut right, you're in exactly the right place. I can help with other plasma setups too, but CandCNC is where I add the most value fast.

Remote or in person?

Both. A lot gets solved over a live screen-share — config, THC, software, post-processor issues. For full setup, commissioning, or crew training, I come to you.

My table just won't cut clean. Can you fix it?

Usually, yes, and usually faster than you'd expect. The Rescue Session is built for exactly this: we get on a call, diagnose the THC/config/motion issue, tune it, and you walk away with a written cheat-sheet of your machine's setup.

Let's get that table cutting

Tell me your controller, table, and the problem — I'll come prepared.

Book a CandCNC session